Bus interface PCI 104 PCI 2.0 Compliant
SRAM disk ● Capacity: 1M Bytes ● Battery backup ● Operation mode: A.Memory Mode B.Disk Mode (Support in Linux only)
Digital Input ● 12 optical isolated channels ● Operating mode: A.General digital input B.Counter mode ● Programmable de-bounce time (0 ms to 255ms, 1 ms resolution). ● Change of State interrupt ● Response time: 20 uS + de-bounce time ● Trigger: rising trigger or falling trigger ● Signal Type: A.Open/Ground switch input B.Digital Logici. Logic High: 3V to 28V Logic Low : 0V to 1.5V8. ● Maximum input frequency 10KHz
Counter ● All digital input support counter mode ● 12 x independent 16-bit counters
Digital Output ● 12 channels ● Output Type: Open drain MOSFET driver ● Output voltage range: 5V to 30V ● Sink Current: maximum 500mA each channel
Pulse Generator ● All digital outputs support pulse generator mode ● 12 x End of pulses interrupt capable counters ● Programmable cycle time, duty cycle and number of cycles. ● Maximum 65535 cycles ● RUN & STOP command ● Programmable time unit: 1 ms, 100ms and 1 second
Timer ● 12 x independent 16-bit timers ● Support Time Out Interrupt ● Programmable time unit: 1 ms and 100ms
CAN bus ● 1 x CAN bus ● 2KV isolation ● Support both CAN 2.0A and 2.0B protocol ● Programmable baud rate: from 5K bps Maximum 1M bps or user-defined baud rate ● Time stamp of CAN message ● API library for user development ● CAN bus device status query ● Device driver for Windows 2000/XP/XPe and Linux
Maximum card Maximum 2 cards can be stacked up in one system
Software ● Windows XP, XPe and Linux device driver and API ● Windows XP, XPe and Linux demo program ● User interface for DIO, SRAM and CAN bus in Linux and Windows XP embedded |